Welcome to KABUSHIKIKAISYA KYOEKI.Website!
Now: Home >>News >>公司新闻

Check the load of the axle and check the load on the axle: the universal reducer often has to limit the maximum radial load that the input shaft and the output shaft extend to the middle

Check the load on the axle:
The universal reducer often needs to limit the maximum radial

load that the input shaft and the output shaft extend to the middle part, and should be

checked.
Lubrication maintenance
Before launching, grease the recommended model and numerical

values in the reducer. The reducer is lubricated with lubricating oil. For vertically

mounted reducers, other lubrication measures may be applied in view of the fact that

lubricants may not guarantee reliable lubrication of the top bearings.
Before running,

inject proper amount of lubricating oil into the reducer. Reducer is usually equipped with

oil filler and drain plug. Therefore, the installation position must be specified when

ordering the reducer.
The operating oil temperature shall not exceed 80 degrees centigrade.
A

permanent lubrication combination reducer is filled with synthetic oil in the manufacturing

plant. In addition, the reducer is usually supplied with no lubrication and is provided

with an oil filling plug and an oil drain plug when supplied. The quantity of lubricating

oil in the reducer listed in this sample is only the estimated value. Set the position of

the oil level plug according to the installation position specified in the order to ensure

proper oiling. The amount of oil in the reducer shall be determined according to different

installation methods. If the transmission power exceeds the heat capacity of the reducer,

an external cooling device must be provided.